tangency
英
美
网络 切线连续; 接触; 相切; 切向参考; 切矢连续
复数:tangencies
英英释义
noun
- (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
- they forget to solder the contacts
- the state of being tangent
双语例句
- The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。 - Emergency Solution to the Equipment Failure of Subnet Access Node in Tangency SDH Loop
相切组网SDH子网接入点失效的应急方案 - Aiming at the problem of tangency point reorganization of digital curve, this paper proposes a digital curve tangency point detection technology based on rotate-angle accumulation.
针对数字曲线的切点识别问题,提出一种基于转角累加的数字曲线切点检测技术。 - Concepts about bridge node and loop tangency are proposed. The principle of the loop shrinkage of the signal flow graphs is deduced from the point of view of the equivalence of node split.
提出了桥结点、环路相切概念,从结点分裂的等价观点出发,导出了信号流图中环路收缩的原理。 - Through square and triangular permutation ways of cutting identical dimension on steel plate, the first model of computational combinatorics is set up by tangency permutation method.
模型Ⅰ主要用“相切排列法”通过“方形排列”及“三角形排列”两种情形建立了在一块固定尺寸钢板上切割一种规格小圆板的组合计算模型; - With the Lagrange multiplier method, the minimum distance of the center of a circle and a quadric surface was provided and the tangency condition of curve and surface was given.
利用拉格朗日乘子法求解二次曲线和二次曲面之间的最小距离,给出了曲线与曲面相切的条件。 - Then everyone should be holding the tangency portfolio.
所有人都应该持有切线投资组合。 - So now the urgent problem for us is to seek the point of tangency and point of balance for Intellectual Property law system which provide protection with Business Method and the perfecting of censoring standard and method of substantial requirements of Business Method patent.
因此,寻找现有知识产权法律制度对商业方法保护的切入点和平衡点,完善商业方法专利实质性条件的标准和审查方法,是我们当前迫切需要解决的问题。 - Their point of tangency is called the pitch point, and since it lies on the line of centers, it is the only point at which the tooth profiles have pure rolling contact.
大小齿轮的接触点称为节点,由于节点位于中心线上,因此节点是齿形轮廓线上唯一做纯滚动接触的点。 - Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
通过对NURBS曲线的控制顶点扰动,采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征,并讨论了多点几何特征同时修改的情况。